This document provides instructions on how to configure an Accelleran E1000 eNB to work with the FreedomFi Gateway. The following procedure is used to take a bare Accelleran E1000 eNB from the box and bring it up to operating configuration with the FreedomFi Gateway.
NOTE: Order matters below, please follow in order or you won’t be able to do certain steps.
Step 1. Connect
1
Connect your computer to the same network as the FreedomFi Gateway
2
Login to the webUI for the radio at the FreedomFi Gateway IP addressNote: wizard should display IP of eth0 or uplink_br0
3
Select the configuration page from the menu in the top left corner
Step 2. ConfigurationConfigure the following elements as shown in the image below
1
EARFCN = 56540
2
Bandwidth = 20 MHz(or your choice if smaller of 10MHz desired)
3
Reference Signal Power = -10(this is full power, can be put lower down to -30 if desired as shown)
4
Physical Cell ID = 1
5
Cell Identity = 256
6
PLMN = 315010
7
TAC = 1
Step 3. IP ParametersScroll down and configure the S1 IP parameters and MME IP to the shown values
1
S1 IP Address = 10.0.2.239
2
S1 subnet mask = 255.255.255.0
3
S1 Gateway = 10.0.2.1
4
MME IP = 10.0.2.1
Well Done! You’re network is ready to go!
Cookie | Duration | Description |
---|---|---|
cookielawinfo-checkbox-analytics | 11 months | This cookie is set by GDPR Cookie Consent plugin. The cookie is used to store the user consent for the cookies in the category "Analytics". |
cookielawinfo-checkbox-functional | 11 months | The cookie is set by GDPR cookie consent to record the user consent for the cookies in the category "Functional". |
cookielawinfo-checkbox-necessary | 11 months | This cookie is set by GDPR Cookie Consent plugin. The cookies is used to store the user consent for the cookies in the category "Necessary". |
cookielawinfo-checkbox-others | 11 months | This cookie is set by GDPR Cookie Consent plugin. The cookie is used to store the user consent for the cookies in the category "Other. |
cookielawinfo-checkbox-performance | 11 months | This cookie is set by GDPR Cookie Consent plugin. The cookie is used to store the user consent for the cookies in the category "Performance". |
viewed_cookie_policy | 11 months | The cookie is set by the GDPR Cookie Consent plugin and is used to store whether or not user has consented to the use of cookies. It does not store any personal data. |